Owner Manual

page 9
9. Shade Installation.
Locate slots on shade and align with nodules on
underside of motor housing. Gently push up on
shade and turn to the RIGHT (clockwise) until it
slides completely into place.
Pull down gently on shade to make sure shade is
secured completely.
10.Wall Control Operation.
shade
8. Canopy Assembly.
slots
The wall control is operational for fan and
light (dimmer).
LOW speed
MEDIUM LOW speed
MEDIUM speed
HIGH speed
turns fan OFF
Move slide knob
up or down for
LIGHT brightness
Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded part
of slotted hole in canopy over loosened screw in
hanging bracket and push up. Twist canopy to lock.
Re-insert screw that was removed and then tighten
both screws securely.
Slide canopy cover up to canopy, aligning rounded
part of slotted holes in canopy cover with
screwheads in bottom of canopy. Turn canopy cover
to the right (clockwise) until it stops.
screw
canopy
hanging bracket
screw
canopy cover