Installation Instructions

Pg. #4
NOTE:
All set screws must be checked and
retightened where necessary, before and after
installation.
MOUNTING OPTION
INST
INST
ALLA
ALL
A
TION
TION
1.
A
B
DOWNROD MOUNT
FLUSH MOUNT
- Remove rubber ring from canopy.
- Place canopy on fan housing by aligning 3 larger holes of canopy over
3 existing screws on the motor housing.
- Secure canopy to motor housing by placing 3 screws and washers
(supplied in hardware package) in the 3 smaller holes in the canopy.
- Insert bolt through hole in shaft and downrod. Be careful not to
damage or cut the fan wires.
- Tighten flat washer and bolt. Secure with cotter pin through hole in the
end of the bolt.
- Secure downrod in position by tightening jam screws. Slide yoke cover
down so it is flush with the motor housing.
Motor
Jam Screw
Yoke Cover
Downrod
Canopy
Fig.
2c
Fig. 2d Fig. 2e
Cotter Pin
Jam Screw
Bolt
Yoke
Yoke
Jam Screw
Flat Washer
Fig. 2a
Fig. 2b
- Take out
fan
motor housing.
-
Remove
cotter pin and bolt from yoke.
- Loosen jam screw in yoke until it is flush with the inside surface.
- Obtain downrod, canopy and yoke cover.
- Place downrod inside canopy and yoke cover.
- Route wires exiting motor through yoke cover, canopy and downrod.
MOUNTING BLADES TO MOTOR
- Insert the blade arm into the fan as shown.
- Tighten the blade arm to motor with the screw and lock washer as shown.
- Slightly turn the blade after installation and repeat the same step for the other blades.
Fig.8
6.
Pg. #9