Installation Instruction

FIG. 1
Wire
Connector
Wire
Connector
Mounting
Screw
Lamp Body
Ground Wire
Junction
Box Screw
Mounting
Back Plate
Driver
Junction Box
Canopy
Rod
B1
A1
D1
C1
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2 Wiring
PREPARATION
1. Shut o the power at the circuit breaker and remove
existing xture, including the crossbar.
2. Carefully unpack your new xture and lay out all the parts
on a clear area. Be careful not to lose any small parts
necessary for installation.
MOUNTING THE FIXTURE (Fig. 1)
3. Remove the mounting screws (C1) from the xture.
4. Choose number of rods suitable for your application.
5. Thread the xture wire through the rods and the canopy.
6. Connect the canopy, rods and lamp body. Make sure all
are tightened.
CONNECTING THE WIRES (Fig. 2)
7. Cut the extra wire. Connect the driver input wires with
junction box wires as shown in Fig. 2, making sure that all
wire connectors (A1) are secured. If your outlet box has a
green or bare copper ground wire, connect the xture's
ground wire to it. Otherwise, conncet the xture's
ground wire directly to the mounting plate using the
green screw provided. After wires are connected,
tuck them carefully inside the junction box.
* Requires Driver to be recessed within
the junction box.
COMPLETING THE INSTALLATION (Fig. 2, 3, 4)
8. Secure the mounting plate to the junction box using
junction box screws (B1). The side of the mounting plate
marked "GND" must face out.
9. Connect the driver output wires with xture wires as
shown in Fig. 2, making sure that all wire connectors (D1)
are secured.
10. Place the xture over the mounting plate and secure with
mounting screws (C1).
11. For slope ceiling application, rotate wire at the top of the
stem to ensure luminaire is aiming down.
Fig. 3
Turn to down
Ø 4 3/4"
Back Plate Dimensions
1 3/8"
1 3/4"
INSTALLATION INSTRUCTION
LED Pendant
2