Installation & Assembly

2.)
1.)
3.)
(L)positive
(N)neutral
ground wire
(green wire)
(A)
(B)
(A)
(B)
(A)
(B)
(A)
(A)
Mounting Bracket
(B)
Canopy
PRODUCT NAME：Saturn II Flush Mount
IMPORTANT: Turn off the power at the main fuse or circuit breaker box before starting installation
Locate all hardware & components before discarding packaging
Cleaning & Care:
Page 2 of (2)
Clean with soft cloth and a mild detergent.
Do not use abrasive cleaner.
PRODUCTS ARE NOT INTENDED
FOR COMMERCIAL USE.
Page 1 of (2)
Please consult your electrician for hanging fixture and wiring.
The fixture is designed to dim with a standard
Triac forward phase dimmer. Dimming levels
will vary by dimmer.
Due to the inrush current wattage should not
exceed 150 watts of product for a 600 watt
dimmer
WARNING: WIRES NEED TO BE CONNECTED
TO DRIVER FOUND IN CANOPY AND SHOULD
NOT CONNECT DIRECTLY TO POWER SOURCE
OR A SHORT MIGHT OCCUR.
Step 1:
Remove mounting bracket from fixture and install
to electrical box Mark where screws at ends of
bracket meet the ceiling. Remove mounting
bracket from ceiling. Drill holes using 3/16”± drill
bit where marked. Install mounting bracket to
outlet box and attach anchors to secure bracket at
ends.
Wire fixture to wires in outlet box. Install
Green wire to Ground Screw.
Install Body (B) to Canopy (A) and
tighten screws on the sides of the canopy to
secure.
Step 3:
Step 2: