Installation instruction

Fig. 1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the crossbar.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts
necessary for installation.
CONNECTING THE WIRES (Fig. 2)
3. Remove the mounting screw (C) from the fixture.
4. Connect the Driver’s input wires to junction box wires as shown in Fig. 2, making sure that all wire connectors (A) are
secured. If your outlet box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise,
connect the fixture’s ground wire directly to the back plate using the green screw provided. After wires are connected,
tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (Fig. 1)
5. Secure the mounting back plate to the junction box using junction box screws (B).The side of the mounting back plate
marked “GND” must face out.
6. Secure the canopy to the mounting plate using the mounting screw (C).
7. There is optional metal clip in hardware bag, remove the screw (D) to replace the plastic clip, secure the metal clip
with screw (D).