Owner Manual

4
4) Connect Power Supply:
Connect power supply to control unit. The electrical connecons must comply with local
authority regulaons and must be done by an authorized electrician.
5) Fill bathtub with water to approximately 40 mm(1.6˝) above the jets and trial run pump for
10-15 minutes. Check all the fings for leaks and test the control funcons. Switch off the
spa pump and leave the unit filled with water (pump is not running) for at least another two
minutes. Check the pump and pipes union connecons for leaks. Hand ghten union
connecons if required.
IMPORTANT: Your bathtub has been factory tested and approved. It is the responsibility of
the installer to test run the bathtub, check all the fings for leaks and test the control funcons.
NON OBSERVANCE WILL INVALIDATE FACTORY WARRANTY.
3) Set the bathtub on two 4x4 pieces of lumber .so you can access from the boom of the bathtub.
1 Total Breakers
Air Blower
RESET
CGFI
Outlet
RESET
120V 15AMP
Dedicated
GFCI Breaker
In the example above, there are 1 Dedicated 15AMP 110V GFCI Breakers.
1. One (1) Dedicated GFCI B
reaker for the Air Massage Blower
Each Accessory Requires a Dedicated 120V 15AMP GFCI Breaker.
THESE CANNOT BE SHARED
(LED LIGHTS & OZONE CAN SHARE A BREAKER)
AIR MASSAGE
ELECTRICAL REQUIREMENTS
WHIRLPOOL & AIR BATHTUB