Caution : You must read this before you proceed Barstool Label Picture Description QTY A Backrest 1 B Left Armrest 1 C Right Armrest 1 D Seat Panel 1 E Front Foot Rest 1 F Back Foot Rest 1
Label Picture Description QTY G Allen Key 1 H Bolt (M6*45MM) 5 I Bolt (M6*35MM) 6 J Bolt (M6*20MM) 9 K Bolt Cap 13 L Washer 20 Before Beginning Assembly:
Overview Backrest(A) Left Armrest(B) Right Armrest(C) Back Foot Rest(F) Seat Panel(D) Front Foot Rest(E) FRONT FACING This Barstool has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Barstool parts, the above picture is to help you put the various parts into perspective. Please read through the instructions herebelow to familiarise yourself with the parts and steps before assembly.
Step 4 C C D D Attach the Right Armrest(C) to Seat(D) using Bolt(I) and Washer(L) with Allen Key(G). DO NOT FULLY TIGHTEN THE BOLTS. Step 5 A C B D Turn the partially assembled chair 180°, to allow you to affix the other arm panel. Repeat Steps 3 and 4 to assemble Left Armrest(B). DO NOT FULLY TIGHTEN THE BOLTS. Step 6 Attach the Back Foot Rest(F) between the back legs using Bolts(J) and Washers(L) with Allen Key(G). DO NOT FULLY TIGHTEN THE BOLTS.
Step 8 If wobble Test again 30CM~50CM Place the barstool on a LEVEL SURFACE to check for wobbles. If it wobbles lift the barstool to some 30cm to 50cm height from the ground. Keep your feet and toes well away from the drop zone. Drop the barstool freely and vertically with the four legs, hitting the ground, all at the same time. This Drop Test will help to ensure that all the bolts and gaps to all reach full alignment status. Test again for evenness on a LEVEL SURFACE.
What is Proposition 65? Proposition 65 is a California law that requires warning labels on products that may contain one of more than 800-plus chemicals or ingredients that the California Office of Environmental Health Hazard Assessment (OEHHA) has deemed to cause cancer or other reproductive toxicity.