Installation Instruction

IMPORTANT

NOTE: The important safeguards and instructions that appear in this

manual are not meant to cover all possible conditions and situations

that may occur. It must be understood that common sense, caution and

care, are factors that can’t be built into any product. These factors must

be supplied by the person(s) caring for and operating the fixture.

STEP BY STEP INSTRUCTIONS

Before starting your installation disconnect the Power by turning off the

Circuit Breaker or by removing the fuse at the fuse box. Just turning the

light off at the light switch is not sufficient to prevent electrical shock.

PREPARE FIXTURE AND

CONNECT THE WIRES

If there is an existing fixture remove it.

Expose the supply wire from the junction box .

Mount the crossbar to the J-box with the supplied

screws.

Connect the black supply wire to the black fixture wire.

Secure with the supplied wire nuts. Connect the white supply

wires to the white fixture wire. Secure with the supplied wire

nuts. Either wrap the green wire around one of the

protruding screws or connect it to the supply ground wire.

Secure all wires with U.L. Certified electrical tape (not

supplied). Tuck all wires carefully into the J-Box.

GENERAL INFORMATION

All electrical connections must be in accordance with all ordinances,

Local and National Electrical Codes. These fixtures are intended for

mounting to a standard 4” x 2 1/2”metal octagon outlet box. The box

must be directly supported by the building structure and U.L. Recognized.

WHAT YOU NEED

•

Screwdriver

• Wire Cutters

• Wiring Supplies as Specified

by Electrical Code

INSTALLATION INSTRUCTIONS

WHAT WE PROVIDE

•

Crossbar

•

Mounting Hardware

•

LED

Before assembling your fixture, please make sure thatyou carefully

read through these instruction sheets. Consider havingyour fixture

installed by a qualified licensed electrician.

PAGE 1
INSTALLATION INSTRUCTIONS IMPORTANT Before assembling your fixture, please make sure that you carefully read through these instruction sheets. Consider having your fixture installed by a qualified licensed electrician. NOTE: The important safeguards and instructions that appear in this manual are not meant to cover all possible conditions and situations that may occur. It must be understood that common sense, caution and care, are factors that can’t be built into any product.
PAGE 2
CONNECT THE DRIVER PLUG 3 MOUNT THE CANOPY 4 2 Connent the plug from the driver to the fixture. Fit the fixture canopy up to the crossbar. Align the holes in the sides of the crossbar with the designated holes in the canopy. Secure with the supplied screws.