Installation & Assembly

INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a later date.
CAUTION
GENERAL
All electrical connections must be in accordance with local and National Electrical Code (N.E.C.)
standards. If you are unfamiliar with proper electrical wiring connections obtain the services of a
qualified electrician.
Remove the fixture and the mounting package from the box and make sure that no parts are
missing by referencing the illustrations on the installation instructions.
1. OUTLET BOX
2. WHITE WIRE
3. BLACK WIRE
4. GROUND WIRE
5. WIRE CONNECTOR
6. WALL PLATE
7. HEX NUT
8. WASHER
9. MOUNTING SCREW
10. MOUNTING SCREW
11. ANCHOR SCREW
12. WALL ANCHOR
13. GREEN WIRE SCREW
14. BALL NUT
15. BACK PLATE
16. SOCKET
17. GLASS
18. SOCKET RING
WARNING: Risk of Fire. Consult a qualified electrician to ensure correct branch circuit
conductor. Min 90ºC supply conductors.
Turn off the main power at the circuit breaker before installing the fixture, in order to prevent
possible shock.
ASSEMBLY AND INSTALLATION
1.Place the Wall plate(6) over the Outbox(1) .Mark the location of keyhole slots on the
wall,remove the Wall plate(6).
2.Drill a1/4” hole at the on the wall,Carefully hammer a Wall anchor(12) into the wall.
3.Replace the Wall plate(6) over the OutBox(1) with the Mounting screw(10).Feed the
Anchor screw(11) through the keyhole and thread into the Wall anchor(12).
4. Pull out the outlet wire and ground wire from the Outlet box(1).Make wire
connections
--Ribbed wire(w/o marking) from light to White wire(2) from power source.
--Smooth wire(w/o marking) from light to Black wire(3) from power source.
--Loop the Ground wire(4) to Mounting bar(6) with a Green screw(9)
5. Attach the Back plate(15) against the Wall plate(6),secure with the Ball nut(14)
6. Put the Glass(17) through Socket(16),then secure by Socket ring(18)
7.Install bulbs:(bulbs not include)
(Please don’t exceed the maximum capacity that recommended on the sockets).
INSTALLATION IS NOW COMPLETED