Installation & Assembly

Warnings and Cautions
1of1
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
Package Contents
B
Mounting
Screw
x4
Inner
Backplate
x1
A
A
Figure 1
Outlet
Box
Outlet Box
Screw
C
B
C
Fixture
Body
x1
FINISH: POLISHED CHROME
PART NUMBER
NOTE: ALL DIMENSIONS ARE ROUNDED UP TO THE NEAREST 1/4"
REPLACEMENT PART DESCRIPTION
NO.
1
QTY.
SHADE
1
4.5”
3”
7”
24”
3”
1
Integrated8WLEDLightSource:
ToolsRequired:Flatheadscrewdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
STEP 1 Install Inner Backplate and Fixture Body-
A. Pass supply wires through Inner Backplate (A). Attach Inner
Backplate (A) to Outlet Box with the head of Green Ground Screw
facing you. Secure it with Outlet Box Screws (not included). Tighten
until snug
B. Refer to Step 2 for wiring connections.
C. Attach Fixture Body (C) over Inner Backplate (A) and secure with
Lock Screws (B). Tighten until snug with screwdrivers.
.
STEP 2 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires between Inner Backplate (A) and
Fixture Body (C).
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 2
Your fixture is now assembled and ready to use. Enjoy!
Figure 3
How To Replace Shade
A. By using Phillips screwdriver unscrew Screws from Fixture Body.
Remove Cap and Shade from Fixture Body as shown.
B. Reverse above steps to reinstall replacement Shade onto fixture.
Cap
Screw
Phillips Screwdriver
Shade
Fixture Body
Assembly Instruction