Assembly & Installation Instructions

ManualsBrandsOrren Ellis ManualsCeiling LightsStarbuck 2 - Light 15'' Simple Drum Flush Mount

ASSEMBLY AND INSTALLATION

INSTRUCTIONS

NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.

2. READ AND SAVE THESE INSTRUCTIONS.

Threaded Pipe (I)

Hardware Package (included):

Mounting Screw (B) Green Grounding

Screw (C)

Wire Connector (E)Mounting Strap (A) Fixture Mounting

Screw (D)

Hex Nut (H)Decorative Cup (G)Finial (F)

WARNING:

TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF

POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.

Outlet Box

House Grounding Wire

Fixture Mounting Screw(D)

Ceiling Pan

Socket

Coupling

Threaded pipe(I)

Glass Shade(M)

Hex Nut(H)

Decorative Cup (G)

Finial(F)

Mounting Strap(A)

Green Grounding Screw(C)

Mounting Screw(B)

Bulb Type A Max.60W

(not included)

1. Attach the two fixture mounting screws to the holes on

the mounting strap, and screw them in 2 to 3 turns.

2. Attach the mounting strap to the outlet box using two

mounting screws.

3. Pull out the source wires from the outlet box. Make wire

connections using wire connectors as follows:

---Connect the hot wire (usually black insulation) from the

fixture to the black wire from the power source.

---Connect the neutral wire (usually white insulation) from

the fixture to the white wire from the power ource.

---Attach the fixture grounding wire (usually green

insulation or bare wire) to the mounting plate with the

green grounding screw, and then connect it to the

house grounding wire with the wire connector.

Carefully put the wires back into the outlet box.

4. Attach the ceiling pan to the mounting strap by inserting

two fixture mounting screw heads into the key holes , and

rotate the pan until it locks in place. Then secure the

screws tightly.

5. Screw the threaded pipe into the coupling, then secure it

with a washer and hex nut.

Note: Depth of threaded pipe may need to be adjusted to

properly fit glass shade,decorative cup and finial.

6. Install 2 x 60W max medium base bulbs (not included) to the sockets.

7. Slip the glass shade through the threaded pipe and upward the ceiling pan. Then tighten them with the metal pad and

hex nut.

Caution: Do not over tighten, breakage of glass shade could be occurred.

8. Slip the decorative cup up through the threaded pipe, secure it with a finial.

Turn off the power at fuse or circuit box

Installation Steps

Turn on the power at fuse or circuit box

Washer (J)

Metal Pad (K)

wire connector (E)