Installation & Assembly

ManualsBrandsOrren Ellis ManualsCeiling LightsZager 5 - Light Kitchen Island Linear LED Pendant

Package Contents

Flathead

screwdriver,Phillipsscrewdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.

LED19W

ToolsRequired:

LightSource:

EstimatedAssemblyTime:

Preparation:

20-30minutes

Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare

present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement

parts.

Warnings and Cautions

1of2

Assembly Instruction Sheet

Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.

These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly

recommend that a licensed, professional electrician perform the installation.

Inner Backplate

Mounting Screw

Fixture

Body

STEP 1 Adjust the Fixture Body Height-

A. Move the safety clip on the cable until there is enough distance for

cable adjustment. Push pin underside of the ceiling canopy and

adjust the cable in or out of the ceiling canopy to achieve your

desired hanging height. Carefully tuck all slack wires inside of the

ceiling canopy.

C. Make sure Fixture Body (D) is horizontal after adjustments. Move

safety clips next to hex nuts inside of the ceiling canopy.

Safety Clip

Hex Nut

Figure 1

Ceiling

Canopy

STEP 2 Attach Inner Backplate to Outlet Box-

A. Pass the supply wires and ground wire through Inner Backplate (A).

Attach the Inner Backplate (A) to the Outlet Box with the head of

Green Ground Screw facing you. Secure it with Outlet Box Screws

(not included). Tighten until snug with screwdrivers.

Supply Wires with

Ground Wire

Figure 2

GND

Crystal

Cable

Outlet Box

Outlet Box Screw

(not supplied)

STEP 3 - Attach the Lanyard

A. The purpose of the lanyard is to provide a means to support the

fixture hands free from the junction box while connecting the

electrical wires.

B. Turn the Button Stop so it may be inserted into a Inner Backplate slot.

Make sure the Button Stop is completely inside the Inner Backplate.

Slowly release the fixture to make sure it is supported by the Button

Stop. Proceed to the wiring steps in the next step. Once you are

complete with the wiring, the Lanyard will push into the junction box

when the fixture is placed for final mounting.

Figure 3

Button Stop

Lanyard

Slot

Summary of content (2 pages)

PAGE 1
Assembly Instruction Sheet Tools Required: Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses. Light Source: LED 19W Estimated Assembly Time: 20-30 minutes Preparation: Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture.
PAGE 2
STEP 4 - Wire Connections A. Wrap bare or green ground wire around green ground screw on the crossbar, no less than 2 inches from the end of the wire. Tighten the green ground screw. B. Use standard wire connectors (not included) to make all wire connections. Twist connectors until wires are tightly joined together. Wrap each connection with approved electrical tape and carefully stuff all the connected wires into the Outlet Box.