Installation & Assembly

2of2
STEP 4 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 4
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
STEP 5 - Attach Fixture Body to Crossbar
A. Fit excess cord and electrical wires in the ceiling canopy properly.
Line up the holes on the side of the ceiling canopy to the mounting
holes on the Crossbar Assembly (A). Secure them with Mounting
Screws (B). Tighten until sung.
Figure 5
FINISH:
POLISHED CHROME
NOTE: ALL DIMENSIONS ARE ROUNDED
UP TO THE NEAREST 1/4"
A
Ceiling
Canopy
B
STEP 6 Install Crystals-
A. Remove lock screws from sockets.
B. Attach Crystals (C) onto sockets and secure with previously removed
lock screws. Hand tighten until snug with screwdrivers gently.
Your fixture is now assembled and ready to use. Enjoy!
Figure 6
Lock Screw
C
D
Socket
GND
9.75”
9”
4.75”
2”
2”
5.5”
2”
3.25”
35.5”
1.5”
91.25” OVERALL
HEIGHT INCLUDES
96” CORD