Manualshelf

Assembly Instruction

ManualsBrandsOrren Ellis ManualsBathroom Vanity LightingZambrano 4-Light Vanity Light
12
Package Contents
(4)MediumBaseBulbs100WMaximumLightSource:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
EstimatedAssemblyTime:
Preparation:
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtobesureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactcustomerserviceforreplacement
parts.
Warnings and Cautions
1of2
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Inner
Backplate
x1
A
D
Shade
x4
B
Mounting
Screw
x4
C
Fixture Body
x1
STEP 1 Install Inner Backplate-
A. Pass the supply wires and ground wire through Inner Backplate (A).
Attach Inner Backplate (A) to Outlet Box with the head of Green
Ground Screw facing you. Secure it with Outlet Box Screws (not
included). Tighten until snug.
Outlet Box Screw
(not supplied)
Outlet Box
Supply Wires and
Ground Wire
A
Figure 1
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
green ground screw.
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
(Step 2 Continued)
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
STEP 3 - Install Fixture Body
A. Attach the Fixture Body (C) over the Inner Backplate (A) and secure
with Mounting Screws (B). Tighten until snug with screwdrivers.
D
Socket
Metal Ring
Bulb (not
supplied)
Figure 4
C
B
A
Figure 3
STEP 4 - Install Shades and Bulbs
A. Remove socket collars and metal rings from sockets.
B. Place Shades (D) and metal rings over sockets and secure with
previously removed socket collars. Hand tighten until snug.
C. Insert bulbs onto sockets and screw snugly into place.
Your fixture is now assembled and ready to use. Enjoy!
Socket Collar
Assembly Instruction Sheet
Thank you for purchasing a product.

Summary of content (2 pages)