Manualshelf

Assembly & Installation Instructions

ManualsBrandsOrren Ellis ManualsAntique Nickel Outdoor Hanging LightsMayon Painted Satin Nickel 1 -Bulb 16.75'' H
12
Top Loop (H)
ASSEMBLY AND INSTALLATION
INSTRUCTIONS
NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.
2. READ AND SAVE THESE INSTRUCTIONS.
WARNING:
TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFF
POWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.
Installation Steps
Turn off the power at fuse or circuit box
Mounting Strap (A)
Mounting Screw (B)
Green Grounding
Screw (C)
Wire Connector (E)
Canopy (I)
Loop Lock (K)
Chain (L)
Hex Wrenches(M)
Hex Nut (D)
Washer (F)
Threaded Pipe(G)
Top Loop (H)
Collar (J)
1. Attach the threaded pipe to the mounting strap (A), and then secure it
with a washer and a hex nut (D).
Loop Lock (K)
Loop Lock (K)
Loop
Glass Holder
Outlet Box
House Grounding Wire
Wire Connector (E)
Fixture Wire
Fixture Grounding Wire
Mounting Strap (A)
Green Grounding Screw (C)
Mounting Screw (B)
Threaded Pipe (G)
Canopy (I)
Hex Nut (D)
Washer (F)
Collar (J)
Chain (L)
Hardware Package (Included):
2. Attach mounting strap (A) to outlet box using two mounting screws (B).
3. Secure the top loop (H) to the threaded pipe (G).
4. Connect the chain (L):
- Determine length of needed chain to achieve desired fixture
height. (To remove excess chain section, use pliers to bend link open)
- Weave the fixture wires and fixture grounding wire through the chain (L),
collar (J) and canopy (I).
5. Connect one end of the chain (L) to the loop using a loop lock (K).
6. Connect the other end of the chain (J) to the top loop (H) using the other
loop lock (K).
7. Thread the fixture wires and fixture grounding wire through the top loop (H),
threaded pipe (G) and mounting strap (A).
8. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the smooth-coated wire (marked) from the fixture to the black wire from the power source.
---Connect the ribbed-coated wire (unmarked) from the fixture to the white wire from the power source.
---Attach the fixture grounding wire to the mounting strap with the green grounding screw, and then connect it
to the house grounding wire with a wire connector (E).
Carefully put the wires back into the outlet box.
Warning: LED electronics can be damaged by electro static discharge (ESD)shock. Before
installation, discharge yourself by touching a grounded bare metal surface to remove this
hazard. To avoid damage, do not touch the LED module.

Summary of content (2 pages)