Owner Manual

• To cut the 3D Wall Panel
• Measure the width/height of the area you need the cut panel
• On the back of the 3D Wall Panel you want to cut, use the ruler/tape measure to measure
and mark where to cut.
Note : since some patterns are not symmetrical, make sure you cut the correct side of the panel to match the pattern on
the wall.
• Draw the line to help guide where to cut.
• Use the heavy duty scissor or utility knife to cut the 3D Wall Panel.
• How to cut around the wall outlet
• Measure the size of the wall outlet (Add 0.5” to each side of the wall outlet)
• Identify where on the panel you need to cut, draw a box for the outlet
• Use a utility knife to cut an opening so that you can use the scissor to cut a hole for the outlet
• The hole you cut on the panel will be about 0.5” larger than the wall outlet on each side. This
is so that the panel won’t block any plug you use.
• After the panel is up over the outlet, it will be hollow around the outlet. To fill the hollow
panel, use the wall filler. Push the filler into the hollow part of the panel and fill it up.
• Remove the excess filler and level it with the cut hole.
• After it is dry, you can paint over the filler.