Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and all
hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear area.
Take care not to lose any small parts necessary for installation.
3. Thread the two mounting screws about 1/4” into the pre-drilled holes in the
mounting plate spaced the same distance apart as the holes in the lamp
body (A).
4. Attach the mounting plate to the Junction Box with the two Junction Box
Screws as shown. The side of the mounting plate marked "GND" must
face out. The junction box is not included.
5. Attach the lamp body(A) into the shade(C), lock it securely with the check
ring(D). NOTE: THE SHADE(C) OF THE PRODUCT MAY VARY.
,
6. Install the light bulb(not included) in accordance with the fixture
specifications. NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
7. While holding the shade assembly towards the ceiling, connect the
electrical wires as Shown in Fig.2, making sure that all wire nuts are
secured. You may have to wrap the connections with electrical tape. If your
outlet has a ground wire (green or bare copper), connect the fixture ground
wire to it. Otherwise connect fixture’s ground wire directly to the mounting
plate with the green screw provided. After wires are connected, tuck them
carefully inside the Junction Box.
8. Raise the shade assembly onto the junction box, aligning screws on
mounting plate with mounting holes in lamp body(A) and lock it securely
with the ball nut (B).
Your installation is now complete. Return power to the junction
box and test the fixture.
JunctionBox
(Notincluded)
Mountingscrew
Green
Screw
(GND)
JunctionBox
(Screw)
A
B
C
D
A
B
C
D
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
`
FIG.2
FIG.1
ALL RIGHTS RESERVED
Or visit us on-line
Thank you for purchasing a product.
Need assistance with parts or assembly? Please call customer service