Installation & Assembly

Page 2 of 2
STEP 1:
Remove the plastic covers which pre-install in the end of the Seat Frame (4) by using Allen Wrench (C).
Please put the Left Leg (2) on a carpeted or padded area.
Insert Top Rail (1) and Seat Frame (4) into Left Leg (2) as shown.
Insert 3 pieces of Bolt (B) from the pre-drilled holes on the bottom of the Top Rail (1) and Seat Frame (4) into each side
on the bottom of Left Leg (2).
Insert 2 pieces of Bolt (A) from the pre-drilled holes on the side rail of the Seat Frame (4) into each end of Left Leg (2) as shown.
Do not fully tighten Bolts (A&B) at this step.
Repeat the same steps for Right Leg (3).
Ax4 Bx6 Cx1
Hardware & Tool required
STEP 2:
Assembly is completed. The loveseat is ready to enjoy now!
Carefully position the table to your desired location.
1
C
A
2
4
2
B
2
The bottom of seat frame and legs
The bottom of seat frame and legs
The bottom of top rail and legs
3
4
2
1
4
B
C
C
ARM LOVESEAT