Installation & Assembly

ManualsBrandsOrren Ellis ManualsCeiling LightsNovalee 1 - Light 4.75" Simple Square Semi Flush Mount

The drawing shown may not exactly match the product enclosed.

However, the installation instructions do apply to this product.

 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.

 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box. Remove old fixture and

all hardware from Junction Box.

2. Carefully unpack your new fixture and lay out all the parts on a clear

area. Take care not to lose any small parts necessary for installation.

3. Attach the mounting plate to the junction box using two junction box

screws as show. The side of the mounting plate marked “GND” must

face out. The junction box is not included.

4. Guide fixture wires through hole in center of mounting plate.

5. Follow wiring instructions carefully (see fig.2).

6. Place the glass(B) insert to the lamp holder, attach the check

ring(D) and collaring ring(C) insert to the socket wrench(E), lock

them securely with the socket wrench(E), then remove the socket

wrench and save it.

7. Place the lamp body over the mounting plate, aligning the mounting

holes with screw hole of the mounting plate on side, then lock it

securely with the mounting screws.

8. Install the light bulb(not included) in accordance with the fixture’s

specifications. NOTE: DO NOT EXCEED THE MAXIMUM

WATTAGE RATING!

CONNECTING THE WIRES (Fig.2)

1. Connect the electrical wires as follows. Connect the Black wire from

the fixture to the black house (hot) Wire. Connect the white wire from

the fixture to the white (neutral) house wire. Make sure all wire nuts

are secured. You may wrap the connections with electrical tape. If

your outlet box has a ground wires (green or bare copper) connect

fixture’s ground wire to it. Otherwise attach the bare copper fixture

wire to the green ground screw on the mounting plate.

2. Tuck the wire connections neatly into the wall junction box.

Your installation is now complete. Return power to the junction

box and test the fixture.

WHITE

HOUSE

Black

WIRES

(

Hot

)

FIXTURE

WIRES

BLACK

WIRES

FIXTURE

Bare

FIXTURE

WIRES

(Ground)

HOUSE

(

Neutral

)

WIRES

White

Green or

WIRES

HOUSE

Copper(Ground)

GREEN

Thread

FIG.2

FIG.1

ASSEMBLING & INSTALLATION INSTRUCTIONS

Or visit us online

Thank you for purchasing a product.

Need assistance with parts or assembly? Please call customer service

Summary of content (1 pages)

PAGE 1
ASSEMBLING & INSTALLATION INSTRUCTIONS The drawing shown may not exactly match the product enclosed. However, the installation instructions do apply to this product. FIG.1 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER. ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR. MOUNTING THE FIXTURE (Fig.1) 1. Shut off the power at the circuit breaker box. Remove old fixture and all hardware from Junction Box. 2. Carefully unpack your new fixture and lay out all the parts on a clear area.