Fire Feature Manual

Using the Ignitor:

1. Read and understand all operating instructions before lighting. Ensure that all protective film

has been removed from stainless burn tray prior to lighting.

2. The burner control knob must be in the “OFF” position.

3. Connect the propane cylinder (see previous pages) and slowly open the valve on the propane

cylinder (propane model). Open the natural gas shut-off valve (natural gas model).

4. Push to create sparks.

5. Push and turn the control knob to the “IGNITE” position to light the burner.

6. Keep the burner control knob pressed in for 15-30 seconds after ignition.

7. If ignition does not occur within 30 seconds, turn the control knob to the “OFF” position and

turn the gas off at the source, wait 5 minutes until the gas has cleared and repeat the lighting

procedure.

8. After lighting, rotate the burner control knob counter clockwise to the “LOW” setting. Observe

the flame and make sure all burner ports are lit. The flame height should be no higher than 13

inches tall.

9. Adjust the flame to the desired height with the control knob.

Using a Long Match or Lighter:

1. Prior to lighting, use a shovel to move the media for

access to the burner.

2. Wearing heat resistant gloves, position a lit

fireplace match or BBQ lighter lighter near the side

of the burner. DO NOT lean over the fire table while lighting!

3. Turn the control knob counterclockwise to “IGNITE”.

4. Remove the match/lighter.

5. After lighting, use a shovel and heat resistant gloves

to carefully move the media back into the proper position.

6. After lighting, rotate the burner control knob counter

clockwise to “LOW” setting. Observe the flame and make

sure all burner ports are lit. The flame height should be no

higher than 13 inches tall.

7. Adjust the flame to the desired height with the control knob.

WARNING

Lava rock and Bali Beach rock is a natural product and water may have become trapped in it over

time. Any trapped water will turn to steam when heated causing the rocks to pop and send pieces

of hot rock flying. When first firing up your new fire feature, keep people and upholstered furniture

at least 15 feet away for the first 15 minutes to avoid injury and damage.

WARNING

If the burner fame goes out during operation, immediately turn

the control knob to “OFF” and let the gas clear a minimum of

5 minutes before attempting to re-light the fire table.

Tank Outside Tank Inside

Please refer to the trouble shooting pages for additional support, beginning on page 18.

LIGHTING INSTRUCTIONS