Owner Manual
Table Of Contents
- IMPORTANT SAFETY INFORMATION!
- Read all instructions before using this heater!
- Connect to properly grounded outlets ONLY.
- Use this heater only as described in this manual.
- NEVER permanently install in a recessed area of th
- Parts and Hardware
- Decorative Log, Crystals and Pebbles
- Operation
- Power
- Methods of Operation
- Control Panel / Remote Control Operation
- (Control panel POWER switch must be ON to use remo
- Temperature Limiting Control
- Remote Control Battery Information
- Care and Maintenance
- Cleaning
- Metal:
- Glass:
- Vents:
- Plastic:
- Maintenance
- Electrical and Moving Parts:
- Storage:
6
STEP 3. Drill a pilot hole into each mark using a 1/4” wood drill bit. A. If screws will go into three
studs, no drywall anchors are needed. B. Tap the drywall anchor(s) (C) carefully into the drywall
holes until they are flush with the drywall surface. Use care to avoid damage.
E
E
B
B
B
B
B
B
B
B
STEP 4. Align the holes in the wall bracket (E) with the pilot holes and drywall anchors. Thread
wood screws (B) through washers and holes in the wall bracket, then directly into the wall studs
and/or drywall anchors. Make sure bracket is level. Tighten all screws securely with ascrewdriver.
ALWAYS unplug this fireplace heater before assembly or cleaning, or before
relocating. Failure to do so could result in electric shock, fire, or personal injury.
D
E
A
A