Installation Guide

Package Contents
1of2
A
Crossbar
x1
(2)G9ClearXenonBulbs40WMaximum,bulbsnotincluded.
20-30minutes
Identifyandinspectallpartsbeforebeginninginstallation.Checkpackagecontentlistanddiagramsbelowtoensureallpartsare
present.Ifanypartsaremissingordamaged,donotattempttoassemble,install,oroperatethefixture.Contactyouroriginalplaceofpurchase.
LightSource:
EstimatedAssemblyTime:
Preparation:
ToolsRequired:Flatheadscrewdriver, Phillips screwdriver,pliers,wirecutters,wirestrippers,electricaltape,safetyglasses.
Fixture Body
x1
D
Figure 1
STEP 1 - Install the Crossbar to the junction box
A. Attach the Crossbar (A) to the Outlet Box with tabs on the top and
bottom. Secure it with Outlet Box Screws (not included), tighten
until snug.
STEP 2 - Wire Connections
A. Wrap bare or green ground wire around green ground screw on the
crossbar, no less than 2 inches from the end of the wire. Tighten the
Figure 2
Green Ground Screw
on the Crossbar
White wire
from outlet box
White wire
from fixture
Black wire from
outlet box (or Red)
Black wire
from fixture
Bare, or Green
Ground wire
from outlet box
Ground wire
from Fixture
G
N
D
Mounting Screw
x2
B
Glass Shade
x2
C
Outlet Box Screws
(not included)
A
Supply Wires
with Ground Wire
Outlet Box
(Step 2 Continued)
green ground screw.
B. Use standard wire connectors (not included) to make all wire
connections. Twist connectors until wires are tightly joined together.
Wrap each connection with approved electrical tape and carefully
stuff all the connected wires into the Outlet Box.
Figure 3
STEP 3 - Install the Fixture Body
A. Place the backplate of the Fixture Body (D) onto the Crossbar (A)
and secure with Mounting Screws (B). Tighten until snug with
screwdrivers.
Backplate
B
D
A
Figure 4
STEP 4 - Install Bulb and Glass Shade
A. Insert bulbs onto sockets and push snugly into properly.
B. Thread the Glass Shade (C) onto the socket and hand tighten until
snug.
Your fixture is now assembled and ready to use. Enjoy!
C
D
Socket
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal.
Do not touch the bulb with bare hands use a cloth or glove.
G9 Clear Xenon Bulb
(not included)
Tab
Installation Guide