Installation Instructions

In a continuing effort to offer the best product possible we reserve the right to change, without
notice, specications or materials that in our opinion will not alter the function of the product.
WARNING - PLEASE READ ALL
INSTRUCTIONS PRIOR TO INSTALLATION
INSTRUCTIONS FOR USE
PART NUMBERS
READ AND FOLLOW ALL WARNINGS AND INSTRUCTIONS BEFORE
INSTALLING OR MAINTAINING THIS PRODUCT.
TURN OFF POWER PRIOR TO ANY WORK ON THE SYSTEM OR
PRODUCT.
DO NOT INSTALL DAMAGED PRODUCT.
Installing, wiring, and maintenance must be done by qualied persons or a
certied electrician in accordance with all local and National Electrical Codes.
Warranty is voided in case of unauthorized modications and/or improper use.
Save these instructions. Use as reference when service or maintenance is
performed.
CAUTION – Do not install any xture assembly closer than 6 inches
(15.24 cm) from any combustible material.
Suitable for dry and damp locations.
De-energize circuit before installation.
Use 2mm allen key to remove back plate.
Remove lm on gasket and apply gasket to exterior of back plate.
Secure back plate with gasket facing mounting surface to J-Box (J-Box
and mounting hardware supplied by others) for use with 3-1/2” and 4”
octagonal or square recessed junction boxes with 2-3/4’’ mounting hole
spacing. (appropriate device ring cover may be required and to be supplied
by others)
Properly ground back plate and xture in accordance with local and national
electrical codes.
Connect primary voltage to the line and neutral leads of the xture. Refer to
product label for required input voltage.
Place xture in desired position, and secure xture to back plate using 2mm
allen key.
Energize circuit and test for proper operation.
Upon proper operation, apply silicone to top and sides of xture base.
(not included)
Part Number Finish
1
2
3
4
5
6
7
8
9
OUTDOOR ECLIPSE 1
Installation Instructions
7 1/8"
5 1/8"
1/2"
3 7/8"
Ground
Back plateGasket
Neutral
Line
Use 2mm
allen key