Owner Manual

4
 The po
wer cord supplied with the heater has three
prongs: two flat blades (live and neutral) and one
round pin (ground). If a 3-slot receptacle is not
available, an adapter MUST be used. The adapter
MUST be properly grounded to the outlet box (see
figure at right). [NOTE: Adapter NOT INCLUDED.]
 SAVE T
HESE INSTRUCTIONS!
Preparation
This product includes a GLASS panel! Always use extreme caution when handling
glass. Failure to do so could result in personal injury or property damage.
Remov
e all parts and hardware from the carton and place them on a clean, soft, dry surface. Parts
and assembly steps are grouped for free-standing or wall-hanging use. Check the parts list to make
sure nothing is missing. Dispose of packaging materials properly. Please recycle whenever possible.
You will need the following tools (not included): Phillips screwdriver; stud finder; level; tape
measure; electric drill; ￠ wood drill bit, hammer.
Parts and Hardware
A – Firep
lace ( 1 )
B – Wood Screws ( 3)

C – Drywall anchors ( 3 )
D – ST5 x10 Metal Screws
(18)
RC – Remote Control
E - Wall Bracket (1) F-Pebbles (1) G – Stand Bracket ( 2 )
H – Plastic Shelf (1) I – M6x15 screws for Stand
bracket (4)
J1 (2) / J2 (2)- Metal parts for
stand