Wireless Mobile Mini Keypad User’s Manual Version: 1.
Introduction This manual is designed to assist you in installing and using the Keypad. Information in this document has been carefully checked for accuracy; however, no guarantee is given to the correctness of the contents. The information in this document is subject to change without notice. System Requirements Microsoft® Windows® 98/Me/2000/XP and MAC OS compatible One USB v. 1.1 or 2.0 Compliant Port Installation Connection with Windows®98/Me 1. Plug the USB receiver connector to your PC. 2.
Windows 2000/XP Operating System 1. Plug the USB receiver connector to your PC. 2. The Found New Hardware Wizard appears and the OS will install the driver automatically. No other steps are necessary. You are now ready to begin using your wireless keypad ID setting Plug the receiver into your notebook’s USB port and turn on the wireless keypad. Pressing the ID button on the receiver, then the ID setting is accomplished.
for some special software, like Excel. Users can know the Num Lock status on the screen and don’t need to care the keypad’s Num Lock status. It makes the method of operation easily. Rechargeable and Extendable cable This addition cable can use for two ways. One is for rechargeable cable and the other is for extendable cable. For rechargeable: 1. Pull out the mini USB plug and the USB connector into two different directions as the graphic shows. And extend the cable to the desired length. 2.
Specification of WKP-250 Operation Force 50±15gm Weight 100gm Total Travel 2.2 mm Operation Frequency 27 MHz/ 1 communication channel/ 1.5M distance Battery type 1 * AAA Nickel-Metal Hydride rechargeable battery Dimension: L×W×H 115 x 75 x 21.
Battery Caution: 1. 2. 3. Risk of explosion if battery is replaced by incorrect type. You must need to use the Nickel-Metal Hydride rechargeable battery. The battery may fail or explode when shorted, overcharged or charged with incorrect polarity. Do not dispose of in fire and prevent explosion. Technical support In an unlikely event that you encounter a problem with ORtek USB Keypad, please visit the web site www.ortek.
FCC RF Exposure requirements: This device and its antenna(s) must not be co-located or operation in conjunction with any other antenna or transmitter. NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS COULD VOID THE USER'S AUTHORITY TO OPERATE THE EQUIPMENT.
