Indoor Fireplace User Manual

5- Plug the lead with the white connector to the lid switch.
Run the other lead flat along the rear of the control panel, under the 2 tabs and attach to the tabs with Ty-
wraps. Plug this lead to the control panel.(Figure 11)
6- Insert the rubber lid cover bumpers in the holes and attach side panel magnets and retainers as shown in
Figure 12.
LID
SWITCH
CONTROL
BOARD WIRE
Figure 11
HOPPER LID
RUBBER BUMPER
SIDE PANEL
RETAINER
LID SWITCH
WIRES
CONTROL
BOARD WIRE
Figure 12
7- Mount the side panels into place. Using 2 screws per hinge.(Figure 13)
8- Secure the louvers in front of the heat exchanger with the four screws supplied. (Figure 14)
Figure 13
Figure 14
9