Owner's Manual
..
~UDIO
BTPSERIES
B L U
ET
O
OT
H®
PATIO
SPEAKER
OU
I
CK
START
GU
IDE
CONTENT:
Master Speaker
Bluetooth Receiver
Internal Stereo Amplifier
Pairing Speaker
110·240V
Water Proof IP67
Rated Power Supply
30
' Speaker Wire
Basic Setup of the BTP
To connect the speakers
together
for
stereo R&L
1) Determine the ideal location where the Patio Speakers are not exposed directly to the elements. Note:
speakers typically should be placed between 8 to 12 feet apart for proper stereo separation.
2) The Master Patio Speaker needs to be located near an AC outlet where you can connect the Power
Supply to the Master Speaker
in
order provide the electrical current needed for the Internal Stereo
Power Amplifier and Bluetooth"' Receiver.
3) The Pairing speaker must be connected to the Master Speaker with the 30-foot Speaker Cable that is
supplied with the kit. The length
of
the speaker cable can be cut down for an exact fit but should not be
extended beyond 30 feet.
Back View
Master Speaker Pairing Speaker
Power Supply
15ft 30ft
Power Supply
The power supply is IP67 rated and waterproof, As a precaution try and limit harsh weather and
over exposure to the elements whenever possible.
"State
of
the art" Bluetooth®
Operation Connects to any
Bluetooth enabled device
Speaker
Wire - Included
Sync to bluetooth-
enable devices like
smartphones and
tablets
Bluetooth Range
30-50 Feet
Range may vary:
Distances, both unobstructed
and obstructed, may differ
depending on device you are
syncing up to the BTP Speakers.
I
Pairing
Speaker
Make sure both your Bluetooth® device and the
BTP Speakers are turned on.
To
pair two Bluetooth enabled devices, both the Bluetooth
Device and the Speakers must be turned on and fully powered
or fully charged. Bluetooth controls are typically found
in
the
device's Setting
or
Connections menu. The Speakers will output
a Bluetooth Sync code that will be received by the Bluetooth
Device. Settings such as Volume, Mute, etc., will be controlled
directly from your Bluetooth phone, tablet or other device.
Only one connection at a time:
The Speakers sync with only one device
at
a time.
You
must
disconnect the current device before Syncing to another device.
I Maste,
Speake,
•
□□
0
Bluetooth
"'