MI5 Powered Amplifier OWNER’S MANUAL
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT USE THIS PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE. TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. TO PREVENT ELECTRICAL SHOCK, MATCH WIDE BLADE PLUG TO WIDE SLOT, FULLY INSERT.
MI5Powered Amplifier Using the controls/ Front Panel Congratulations on your purchase of OSD Powered Amplifier. Power MI6 Powered Amplifier. Please take a few moments to read this entire manual, and be sure to retain this document for future reference please read and observe all safety instructions detailed on page. The front panel switch will manually switch the MI5 Powered Amplifier on or off. A blue led behind the faceplate lens indicates its power status.
Master Level Control Each channel is able to control its volume independently relative to the other channel. At the bottom left of the rear panel, there are 2 screwdriver adjustment knobs which correspond to the volume level of the channel identified by a channel designator below it. As an example, if the “line 1 Input” source was a CD Changer, The delay could be adjusted to prevent switching back to the “Line 2 Input” source while the changer moves from one disk to another.
This limited warranty applies only to purchases from authorized OSD Electronics retailers. This limited warranty is extended only to the original purchaser. Consumers are required to provide a copy of the original sales invoice from an authorized OSD dealer when making a claim against this limited warranty. This limited warranty only covers failures due to defects in materials or workmanship that occur during normal use.
Stereo Setup The distributed audio is then passed on to be used by additional zones or sub zones in the distributed system via the Line 2 outputs. The Audio output of a local source, such as MP3 Player, CD, television, computer, etc.. Is connected to the MI5 Powered Amplifier via the television, computer etc.. Is connected to the MI5 Powered Amplifier via the Line 1 inputs, and whenever the local source is active its signal will take priority over the distributed audio signal present at Line 2.