User's Guide

7
Bluetooth
®
Pairing:
1. Press the Source Select to BT when it
begins ashing it’s ready to connect.
2. Activate Bluetooth on your phone/tablet and
start searching for new Bluetooth devices.
3. When your phone/tablet nds NERO
STREAM WRS, choose this unit and begin
pairing.
4. Removing a Device: Press and hold the
Connect/Reset button for 2 seconds.
Wi-Fi
®
Connection:
1. Download and install the OSD Audio App for
your iOS or Android device.
2. Select Wi-Fi
®
from the source button then
wait for the musical tone from the amp signify-
ing it is ready to connect.
3. Link your device to the NERO STREAM
and your Wi-Fi network by following the setup
steps in the app.
Enable Wi-Fi
®
Be sure your phone or tablets
Wi-Fi is turned on.
Wi-Fi Network
Be sure the NERO is powered
up and your phone or tablet is
set to the same Wi-Fi network
as the NERO.
Set Up
In your devices Wi-Fi settings
look for NERO STREAM_XXXX
and select to connect.
1. Connect the power cord to the back of the
amplier then connect it to a wall outlet.
2. Connect any suitable device to the Aux input
(see page 5).
3. Press the power button on the front of the unit,
after two seconds the unit will enter working status
and the input indicator will light up.
4. Press the Source Select Button to choose your
source, Bluetooth
®
, Wi-Fi
®
or AUX. Control the
playback via the OSD Player App.
Note: Always select the desired source for the
audio source to work.
Connect Your Device:
Connect your CD player phone/tablet/MP3 via its
RCA/AUX cable to the RCA L/R AUX input. Make
sure you connect the “L” plug to the left input
channel and the “R“ plug to the right input channel.
Connect your speakers to the Speaker
Output. Make sure you connect the -/+ and
the L/R cables to the right input.
SETUP
APP CONTROL / USER INTERFACE