STEREO SPEAKER SELECTORS OSD-SSVC6D SSVC6D ON OFF A B ZONE 1 ON OFF ZONE 2 ON OFF ZONE 3 ON OFF ZONE 4 ON OFF ZONE 5 USER MANUAL ON OFF ZONE 6
TABLE OF CONTENTS Important Safety Precautions.............................................................................................. 2 What’s Included................................................................................................................... 2 Introduction.......................................................................................................................... 3 Front Panel........................................................................................
INTRODUCTION The speaker selector series has been designed to let you add speakers around your home or office while maintaining a central control. Turn them on and off and adjust the volume without requiring additional amplifiers.
REAR PANEL: 3. One Source A and B Input, Removable Connector 4.
INSTALLATION TIPS • OSD Audio recommends using 16 AWG gauge stranded wire. For runs longer than 50’, 14 gauge is recommended. • You can mix 4, 6, 8 and 16 ohm speakers. • Since speakers have different efficiencies, more efficient speakers will sound louder than less efficient speakers. Select speakers with the same efficiencies (I.e., sensitivity: a typical measurement is 90 dB/watt) • Wire according to state and local laws.
OPERATION For initial connection, OSD Audio recommends selecting one speaker pair located closest to the room where you are operating the SSVC6D. Select this speaker pair and turn on your receiver/amplifier. Make sure sound is coming from both speakers. Before you turn on additional speakers, read the information below. This Volume Control is a passive device (no power supply) that takes a signal from the source and allows you to attenuate or turn the sound down. It does not add or increase the gain.