Owner's Manual

XMP500DSP
OWNER’S MANUAL
3
775 Columbia St.,Brea. CA92821
Stereo,Bridging
13. Voltage Selector Switch
The amplifier can be used on 110 - 120V or 220 - 240V(50/60)
line voltage. To change the operating line voltage, turn the power
off using the power button and unplug the power cord. Remove the
plastic cover screws and the plastic cover over and screws over the
voltage selector switch.
NOTE:
If required,remove the IEC line core and replace with an IEC AC cable
that matches the AC wall socket,this should be a 10A rated cable. When
the voltage selector switch is changed, the fuse must also be changed
to continue to provide protection to the amplifier.
14. Fuse Holder
This is the power fuse access.
WARNING! In the event the fuse must be replaced,the replacement
fuse must match exactly the original fuse value ir damage ti the amplifier
may result. Use a 10A 120V or 5A 240V fuse.
CAUTION! Before replacing the fuse, disconnect the power cord from
the power receptacle.
15. Power Cord Receptacle
The supplied power cord needs to be connected to this receptacle in
order for the amplifier to work properly.
Balance
Left/Right
Presets