Instructions/Assembly Guide

ManualsBrandsOSP Home Furnishings ManualsBookcasesBrookings White Wood 5-Shelf Ladder Bookcase

BNN21

BKS21

MED21

HSB21

Assembly Instructions - Important:

Carefully unpack and identify each component before attempting to assemble. Refer to parts list. Please take care when

assembling the unit and always set the parts on a clean, soft surface. If you require any assistance with assembly, parts or

information on other products, please visit our website: www.ofﬁcestar.net or call or write us.

BNN21 / BKS21 / MED21 / HSB21

July, 2019

LADDER BOOKCASE

Summary of content (6 pages)

PAGE 1
July, 2019 BNN21 / BKS21 / MED21 / HSB21 LADDER BOOKCASE BNN21 MED21 HSB21 BKS21 Assembly Instructions - Important: Carefully unpack and identify each component before attempting to assemble. Refer to parts list. Please take care when assembling the unit and always set the parts on a clean, soft surface. If you require any assistance with assembly, parts or information on other products, please visit our website: www.officestar.net or call or write us.
PAGE 2
1. Do not use this product unless all screws and bolts are securely tightened. 2. Check that all screws and bolts are tight every three months or as needed. 3. Dispose of packing material properly. Do not use plastic cover as head covering. It may cause suffocation. 4. Do not use this product as a stepladder. 5. Use this product for its intended purpose only. 6. FOR INDOOR RESIDENTIAL USE ONLY.
PAGE 3
PARTS (A) Upper Left Frame (1 PC) (B) Upper Right Frame (1 PC) (C) Lower Left Frame (1 PC) (D) Lower Right Frame (1 PC) (E) Shelf (1 PC) (F) Shelf (1 PC) (G) Shelf (1 PC) (H) Shelf (1 PC) (I) Shelf (1 PC)
PAGE 4
HARDWARE LIST NO DRAWING DESCRIPTION SIZE QUANTITY 1 Bolt 1/4” x 25mm 20 PCS 2 Screw 5/32” x 20mm 8 PCS 3 Wooden Dowel 10 x 40mm 4 PCS 4 Support 40 x 15 x 3mm 4 PCS 5 Allen Wrench M4 1 PC 6 Anti-Tip Kit N/A 1 PC Phillips Screwdriver also needed for assembly (not provided). STEP 1 (E) (F) (I) (H) (G) (B) (5) (1) (D) DO NOT FULLY TIGHTEN BOLTS (1).
PAGE 5
STEP 2 (A) (1) (C) (5) DO NOT FULLY TIGHTEN BOLTS (1).
PAGE 6
STEP 4 (4) (2) APPLY FIRM PRESSURE TO ALIGN & FULLY TIGHTEN ALL SCREWS & BOLTS. ANTI-TIP KIT INSTALLATION STEPS: Place shelf in desired location. Secure one Bracket to wall using one Long Screw, FULLY TIGHTEN LONG SCREW USING PHILLIPS SCREWDRIVER (not provided). Secure remaining Bracket to rear of shelf using one Short Screw, FULLY TIGHTEN SHORT SCREW USING PHILLIPS SCREWDRIVER (not provided). Loop Safety Strap through Brackets and fasten Safety Strap.