Installation Guide

IMPORTANT NOTE:

1. Use hand tools only for assembly as power tools may cause damage

2. Carefully remove any staples used for packaging.

Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.

STEP 1 Attach Left Side Frame (B) and Right Side Frame (C) to Rear Cross Support (H) and Front Cross Support (G) using two Bolts (I2) for each side

frame. DO NOT FULLY TIGTHEN BOLTS (I2).

STEP 2 Attach side frame assembly to Glass Top (A) using four Bolts (I3). DO NOT FULLY TIGTHEN BOLTS (I3).

PART QTY

A. Glass Top ...................1

B. Left Side Frame ..............1

C. Right Side Frame .............1

D. Back Support .................2

E. Top Shelf ....................1

F. Bottom Shelf .................1

G. Front Cross Bar ..............1

H Rear Cross Bar ...............1

I1. Bolt (3/8’’) ...........4 + 1 Extra

I2. Bolt (15/32’’) ........12 + 1 Extra

I3. Bolt (11/16’’) .........4 + 1 Extra

J. Allen Wrench .................1

NWP27-BK

NEWPORT 2 SHELF BOOKCASE

ASSEMBLY INSTRUCTIONS

NWP27-BK

NEWPORT 2 SHELF BOOKCASE

ASSEMBLY INSTRUCTIONS

STEP 3 Attach Bottom Shelf (F) and Top Shelf (E) to Left Side Frame (B) and Right Side Frame (C) using four Bolts (I2) for each shelf. APPLY FIRM

PRESSURE TO ALIGN ASSEMBLY AND FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (J).

FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (L).

STEP 4 Attch both Back Supports (D) to rear of assembly using four Bolts (I1). FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH (J).

ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING BOOKCASE.

STEP 1

STEP 2

STEP 3

STEP 4