Installation Guide

NOTES IMPORTANTES:
1. Utilisez les outils à mains seulement pour l’assemblage comme les outils lourds peuvent
provoquer des dommages
2. Enlevez soigneusement n’importe quelles agrafes utilisées pour l’emballage.
LIMITED WARRANTY
OSP Designs Warrants, to the original purchaser its products to be free from defects in material and workmanship for a period of 90 days. Defects
and damage from misuse, abuse, negligence, alteration, accident, vandalism, rusting, acts of nature or any other event beyond the control of OSP
Designs is not covered. The warranty does not cover cosmetic damage that may result from normal use. Liability for incidental or consequential
damages is excluded. The user assumes all risk of injury resulting from use of this product. This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
To make a warranty claim, contact Customer Service, provide model number, sales receipt and description of the problem. It is the customer’s
responsibility to prepay freight on any components returned to the factory. OSP Designs will pay return freight on components covered under
terms of warranty.
Our quality standards are among the highest in the industry. Sometimes, no matter how hard we try, there are times when hardware is missing.
Our Parts Department will do everything possible to promptly remedy the problem. Contact us via email parts@officestar.net, by Fax
1-909-930-5629, or toll free parts number 1-800-950-7262, Monday through Friday 8:00 a.m. - 5:00 p.m. Pacific Time. OSP Designs P.O. Box
3520 Ontario, California 91761 USA
WARNING
1. Do not use this product unless all screws and bolts are securely
tightened.
2. Check that all screws and bolts are tight every three months or as
needed.
3. Dispose of packing material properly. Do not use plastic cover as
head covering. It may cause suffocation.
4. Do not use this product as a stepladder.
5. Use this product for its intended purpose only.
6. Intended for residential use only
PIÈCE QTÉ
1. Haut ........................1
2. Jambes .....................4
3. Soporte .....................1
4. Vis ........................20
5. Clé allen .....................1
PTR432
PATTERSON METAL TABLE
OPERATING INSTRUCTIONS
© Office Star Products septembre 2014
ÉTAPE 1
ÉTAPE 2
2
3
1
4
5
4
5
PTR432
TABLE EN METAL PATTERSON
INSTRUCTIONS DE MONTAGE
Enlever toutes les pièces du carton, les organiser selon les numéros de pièce indiqués sur la liste et vérifier les quantités des pièces.
ÉTAPE 1 Attacher les Jambes (2) vers le Haut (1) à l’aide de quatre Vis (4) pour chaque Jambe (2). NE PAS SERRER LES VIS.
ÉTAPE 2 Fixez le Support (3) entre les Jambes (3) à l’aide d’une Vis (4) pour chaque Jambe (2). TOURNER LA TABLE DE LA POSITION
VERTICALE, APPLIQUIER UNE PRESSION FERME POUR ALIGNER ET ENTIÈREMENT SERRER TOUTES LES VIS EN
UTILISANT LA CLÉ ALLEN (5).
ATTENTION : S’ASSURER QUE TOUTES LES VIS SONT BIEN SERRÉES AVANT D’UTILISER LA TABLE.