User Guide

For more complete product information visit www.sylvania.com Symbols/Footnotes on page 35-39
3
I
N
C
A
N
D
E
S
C
E
N
T
Finishes
W or SW - Soft White
DAY - Daylight
®
Y - Yellow
B - Blue
R - Red
G - Green
A - Amber
IC - Iridescent clear
FL - Flood
SP - Spot
IF - Inside frost
AIC - Amber iridescent clear
BULB IDENTIFICATION
Light Center Length (L.C.L.) is the distance
from the center of the light source to the fol-
lowing point for the base used: Screw
bases...bottom base contact; Bayonet cande-
labra and medium bayonet...top of base pins.
BASE IDENTIFICATION
Typical bases are shown. One lead-in wire is
soldered to the center contact and the other
soldered or welded to the upper rim of the
base shell. Base shells are typically made of
brass or aluminum. ANSI designations are in
parentheses.
FILAMENT IDENTIFICATION
A FILAMENT designation consists of a prefix
letter to indicate whether the wire is straight or
coiled, and a number to indicate the arrange-
ment of the filament on the supports. Prefix
letters include: C (coiled) --wire is wound into
a helical coil or it may be deeply fluted; CC
(coiled coil)--wire is wound into a helical coil
and this coiled wire again wound into a helical
coil.
ADDITIONAL INFORMATION
Lamps Listed 115-125 volts (design voltage
120), 120-130 volts (design voltage 125),
125-130 volts (design voltage 130) and 230-
250 volts (design voltage 240) are intended
for use on circuits normally varying within
these voltage limits.
Bulb size - Max. Diameter (Divide by 8)
A-21 - 21⁄8 = 2 5⁄8” Dia.
G-40 - 40⁄8 = 5” Dia.
T-12 - 12⁄8 = 1 1⁄2” Dia.
PS-30 - 30⁄8 = 3 3⁄4” Dia.
C-2R
C-8
CC-8
C-11V
C-5
C-2V
CC-2V
C-9
CC-9
C-11
CC-11
C-7A
CC-7A
C-6
CC-6
Candelabra
cand. (E12)
Intermediate
Inter. (E17)
Mogul End Prong
Ext. Mogul
End Prong GX16d
Medium (E26) &
Medium Brass
(E26)
Double Contact
Bayonet D.C.
Bay (BA15D)
3 Contact
Medium
3 C Med (E26D)
Medium Skirted
Med. Skirt
(E26/50x39)
Mogul Screw S14s Med Side Pr. Screw Terminal
G53
3 Contact Mogul
010_INC_drop.qxd 12/4/07 8:19 AM Page 3