User Guide

SYMBOLS & FOOTNOTES FOR DISPLAY/OPTIC LAMPS
Footnote Description
135 Lamp life may vary depending on duty cycle and application.
136 Connector = Female.
137 Connector = Male.
138 Snap-on connector, female / male contact.
139 In horizontal operation position it is recommended that the "lead connection" wire be in the top position with filler tip facing down.
140 This lamp type is twice the life of the ANSI standard version.
141 This lamp type is twice the life of the standard version.
142 Please see Product Number 58795 for double life version.
143 Please see Product Number 58789 for double life version.
144 Please see Product Number 58794 for double life version.
145 XERADEX lamp life is rated in terms of 70% of initial UVC output on a continuous burn cycle.
146 Lamp also available with connecting cable and plug-in contact. XBO R 100W/45 C OFR (Product Number 69191).
147 Base is KF50 flange fitting; lamp is designed for use in vacuum environments at pressures above 300 mbar.
148 Base is KF40 flange fitting; lamp is designed for use in high vacuum environments at pressures above 30 mbar and below 10^-3 mbar.
149 Please see Product Number 58779 for double life version.
150 Please see Product Number 58819 for double life version.
151 Please see Product Number 58821 for double life version.
152 Maximum permitted base temperature is 350 degrees C at molybdenum foil / pinch seal region.
153 Distance b = Ignition Electrode. Base for ignition electrode is SFc 6-3.
154 HBO 200W L1 and HBO 200W L2 can be operated on AC or DC.
155 HBO 200W L1 (Product Number 69218) technical data if operated on AC current: Volts = 61 +/- 4, Current (A) = 3.6.
156 HBO 200W L2 (Product Number 69220) technical data if operated on AC current: Volts = 53 +/- 4, Current (A) = 4.2.
157 Distance a is from end of base to the respective electrode tip (cold) - see lamp drawing.
158 Base is KF50 flange fitting; lamp is designed for use in high vacuum environments at pressures above 200 mbar and below 10^-3 mbar.
159 For use indoors or outdoors. When used outdoors, protect the lens of the bulb from direct contact with moisture (rain, snow, etc.) to avoid
cracking or breaking.
160 2000hr warranty against non-passive lamp failure.
161 Optimized lamp eXtreme Seal (XS) technology to withstand interior base temperatures of up to 450 degrees celsius.
162 When operated on electronic control gear (ECG) service life extended to 3000h.
163 Also available with 850h, HBO 3501 W/PI: NAED 69127.
164 SHP - series (Super High Performance Technology).
165 Lamp focus is 60mm in front of reflector rim.
166 Lamp is part of the SharXS HTI lamp series. All SharXS HTI lamps are identical in terms of their shape, size, and bases.
167 Base has notch for pre-alignment.
168 Lamp current not to exceed 7.2A.
169 125 mm (front ring to plug) and 95 mm (rear cap to plug) silicon cables terminated with MATE-N-LOK plug no. 350809-1 with pins no.
926868-3 by AMP Inc.
170 It takes time for the mercury in the lamp to evaporate. Typically 95% of luminous output are generated after approximately 120 seconds. For
quality inspection purposes allow for five minutes burning time.
171 Excessive airflow may lead to mercury condensation in the discharge lamp bulb and consequently to a performance drop.
172 Operation time after which either aperture lumens decrease to 50% of initial value or the lamp voltage reaches 115 V and the lamp cannot be
ignited. Switching cycle: 210 minutes on / 30 minutes off.
173 Operational bulb wall temperatures lower than 850˚C may lead to mercury condensation and prevent the lamp from reaching stable operation
conditions; temperatures higher than 950˚C may lead to premature failures of the lamp.
174 For rectangular aperture of 5.0 x 3.8 mm (hor. x vert.) at working distance 17.3 mm.
175 Output is understood as total energy in the range 320 … 500 nm focused on an aperture with diameter d at working distance a in front of the
reflector.
D
I
S
P
L
A
Y
O
P
T
I
C
R
E
F
E
R
E
N
C
E
For more complete product information visit www.sylvania.com
278
071_DO_drop.qxd 12/13/07 3:25 PM Page 278