User Guide

ManualsBrandsOSRAM SYLVANIA ManualsFluorescent TubesOsram Sylvania 20876 18W Triple Compact Fluorescent Amalgam Lamp with 4-Pin Base, 3000K Color Temperature, 82 CRI, 4.4-Inch

100

For more complete product information visit www.sylvania.com Symbols/Footnotes on page 101-102

METALARC

SAFELINE

, S-Type Lamp

THE FOLLOWING INSTRUCTIONS MUST BE COMPLIED WITH TO AVOID RISK OF PERSONAL INJURY, PROPERTY DAMAGE AND POOR LAMP PERFORMANCE.

I. RUPTURE RISKS: This Metal Halide lamp is constructed of an outer glass bulb with an internal arc-tube. Metal Halide arc-tubes operate at high pressure and at

very high temperatures and can unexpectedly rupture due to internal causes or external factors such as a ballast failure or misapplication. An arc-tube rupture can

burst and shatter the outer glass bulb resulting in the discharge of glass fragments and extremely hot particles. In the event of such rupture,

THERE IS A RISK OF

PERSONAL INJURY, PROPERTY DAMAGE, BURNS AND FIRE.

TO REDUCE THESE RISKS:

1. Only operate lamp in an enclosed fixture with a lens/diffuser material able to contain hot lamp fragments (up to 2012°F, 1100°C). If you are uncertain,

contact your fixture manufacturer. When operated within 15° of vertical, this lamp may be operated in an open fixture PROVIDED THE INSTALLATION IS

NOT NEAR PEOPLE OR FLAMMABLE OR COMBUSTIBLE MATERIAL.

2. Only operate lamp with compatible ballast and fixture. (See catalog for specific information.)

3. Only operate lamp in designated operating positions. (See catalog for illustration.)

4. Lamp must be turned off for a minimum of fifteen minutes at least once a week.

5. Never expose an operating lamp to moisture (such as rain, sleet or snow).

6. Replace lamp if outer glass bulb is scratched, cracked or damaged in any way.

7. Electrically insulate any metal support in contact with the outer bulb to avoid glass decomposition.

8. Replace lamp at or before the end of rated life. (See catalog for rated life.)

FOR APPLICATIONS WHERE AN ADDITIONAL MEASURE OF SAFETY IS DESIRED, LAMPS USING AN INTERNAL SHIELD DESIGNED TO CONTAIN AN ARC-TUBE

RUPTURE ARE AVAILABLE.

II. ELECTRICAL SHOCK AND BURN HAZARD: Do not remove or insert lamp while power is on. If outer glass bulb is broken, shut off power immediately and

remove lamp after it has cooled.

III ULTRAVIOLET RADIATION EXPOSURE: This lamp should self-extinguish within 15 minutes after the outer envelope is broken or punctured. If such damage

occurs, TURN OFF AND REMOVE LAMP to avoid possible injury from hazardous shortwave ultraviolet radiation. This product conforms to the following federal

regulations: U.S.A.: 21 CFR 1040.30 and CANADA: SOR/80-381

IV. LAMP INSTALLATION:

1. Screw lamp firmly but not forcibly into socket to avoid breakage.

2. Never install the lamp into an ordinary household socket.

V. BROKEN ARC-TUBE: Take care in handling and disposing of this lamp. If arc-tube is broken, avoid skin contact with any of the contents and fragments. See

Product Safety Data Sheet for further details.

ANSI Luminaire Code S

ENCLOSED FIXTURE/Open if meets

requirement of Paragraph I.1 below

040_HID_drop.qxd 12/12/07 3:14 PM Page 85