Owner manual

BackLED Plus Series LED Lighting

System

INSTALLATION GUIDE

WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION

TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE PERFORMING

INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.

Failure to install the power supplies and/or LED modules in accordance with the National Electric Code (NEC), all applicable

Federal, State, and local electric codes as well as the specific Underwriters Laboratories (UL) safety standards for the

installation, location and application may cause serious personal injury, death, property damage and/or product malfunction.

These instructions are guidelines for installation of LED modules and power supplies. Installation requirements may vary

depending on the application. Licensed electricians should provide all installation services for connection for both primary

and secondary (input/output) of the power supplies.

1.0 Prepare for Installation

1.1 Tools Required:

- Wire stripper/cutter

- Screwdriver

- Measuring tape

1.2 Supplies Required:

- PLTC Cable

- Wire nuts

- #8 hex/pan head type screws or rivets

1.3 Carefully remove existing neon or fluorescent tubes, HID or incandescent light sources

and power supplies and/or ballasts if necessary.

1.3.1 Make sure power is turned off.

1.3.2 Remove all existing screws, sockets and wiring.

1.3.3 Dispose of all old sign components in the proper manner.

1.3.4 Clean the inside of the sign ensuring it is free of dirt.

www.sylvania.com/LED

LED349

PAGE 1
www.sylvania.com/LED BackLED Plus Series LED Lighting System INSTALLATION GUIDE WARNING: ONLY QUALIFIED PERSONNEL SHOULD PERFORM INSTALLATION TO AVOID ELECTRICAL SHOCK OR COMPONENT DAMAGE, DISCONNECT POWER BEFORE PERFORMING INSTALLATION OF THE POWER SUPPLIES, MODULES, AND/OR RGB CONTROLLERS.
PAGE 2
.0 Mechanical Installation 2.1 Measure the appropriate amount of product for the length of the application and cut. Cuts can be made between any two modules. BackLED L PLUS BackLED M PLUS 2.2 Peel plastic tape backing to expose double sided tape and place modules in desired location. 2.3 Secure the modules through the mounting hole using screws or rivets. Do not overtighten. 3.0 Electrical Installation 3.
PAGE 3
.2 Cap off any unused connection wires when finished. 3.
PAGE 4
.0 Troubleshooting Guide Problem Possible Cause Corrective Action Entire sign does not light No input power Check AC connection to power supply. Check power supply connection to modules. Check DC polarity- power supply red output wires must be connected to red striped module wires, power supply blue output wires must be connected to gray striped module wires. Verify power supply output voltage is 12V +/- 1.