Manual

OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : [phone] - 200
(kostenpichtig / charges apply)
Fax.: [phone] - 202
www.osram.com
www.osram.de
Page 1 of 2
40083215072732
4008321507273
Control unit
Fitting instructions
VI 2011
DIM_MULTIeco_ma0611en_we1.02.indd
DIM MULTIeco
Description
Purpose and application
The DIM MULTIeco control unit controls the lighting at the work-
place and in ofces according to the level of daylight and the
presence of persons to increase comfort and save energy.
The control unit can be installed in luminaires (e.g. oor stan-
ding luminaires) or in suspended ceilings.
Installation
Safety instructions
The control unit must only be installed and put into operation
by a qualied electrician. The applicable safety regulations and
accident prevention regulations must be observed.
WARNING!
Exposed, live cables or damaged housing.
Danger of electric shock!
• Only work on the control unit when it is de-
energised.
CAUTION!
Destruction of the control unit and other devices
through incorrect mounting!
• Do not operate any other control units on the
control line.
• Use the LMS CI BOX mounting kit for ceiling
installation.
• Ensure that the external pushbutton is designed
for the mains voltage.
• Do not wire the control and pushbutton lines
with an external voltage, especially not a mains
voltage of 230 V.
• Do not exceed the maximum number of electro-
nic control gears.
Function
The control unit can be operated in two different operating
modes, see also “Setting the operating mode”:
Brightness control
The sensors measure the brightness in the area to be regulated
and keep this to an adjustable set value by introducing articial
light according to the amount of daylight available.
The sensors also detect the presence of people.
When the level of daylight is sufcient or people are no longer
present, the connected luminaires switch off after an adjustable
delay period.
Brightness control, presence detection and automatic switch-on
can be activated and deactivated using various modes.
Brightness reduction
If persons are present, the luminaires are dimmed to an adju-
stable brightness value.
If no persons are present, the brightness drops to a xed stand-
by value of 50%, 30% or 10% after an adjustable delay time.
Automatic switch-on and automatic switch-off during periods
of prolonged absence can be activated and deactivated using
various modes.
Design
The control unit is made up of the following components:
• Adjusting screw for switch-off delay time (A)
• Sensor connection (B)
• DIP switch (C)
• Pushbutton connection (D)
• Control line connection (E)
• Load contact (F) optional
• Power supply connection (G)
DIM MULTIeco
Sensor
L
N
L’
1…10 V+
1…10 V -
B
C
A
D
E
G
F