Manual

OSRAM GmbH
Kunden Service Center
Customer-Service-Center (CSC)
Steinerne Furt 62
86167 Augsburg
Germany
Tel : [phone] - 200
(kostenpichtig / charges apply)
Fax.: [phone] - 202
www.osram.com
www.osram.de
40083214217776
4008321421777
Page 1 of 2
Radio receiver
Operating instructions
VIII 2009
EASY-RC_ba0908en_we1.01.indd
EASY RC
A
D
B
C
E
F
Description
Purpose and application
The EASY RC radio receiver is used to receive wireless radio
signals from EASY hybrid remote hand-held transmitters or
EASY Color Drive wall operating units and transmit these to
EASY control units.
The radio receiver can be installed in luminaires or, with the
optional ECO CI KIT, in suspended ceilings.
Operation
Training hand-held transmitters/wall
operating units
Up to 8 EASY hybrid remote hand-held transmitters or EASY
Color Drive wall operating units can be trained into the radio
receiver. If this number is exceeded, the oldest connection is
automatically deleted.
Note: To operate the hand-held transmitters and wall operating
units, see the separate instructions.

Activate the radio transmission of the hand-held transmitter
or wall operating unit.

Press the „Connect“ button of the desired hand-held trans-
mitter or wall operating unit.
• Wall transmitter (E): lower part of housing
• Hand-held transmitter (F): battery compartment
The display of hand-held transmitter/wall operating unit
shows „Connecting“.

Press the „Connect“ button (D) of the radio receiver within
the next 30 seconds.
The LED (A) of the radio receiver ashes orange.
Training was successful:
• The display of the hand-held transmitter/wall operating
unit shows „Success“.
• The LED of the radio receiver lights up green.
Training failed:
• The display of the hand-held transmitter/wall operating
unit shows „Not linked“ or „No RF link“.
• The LED of the radio receiver lights up red.

Press the „Connect“ button on the radio receiver and hand-
held transmitter/wall operating unit to end the training mode.
The training mode is ended automatically after 30 seconds.
Function
The radio receiver converts the radio signals of the hand-held
transmitters and wall operating units into the corresponding
telegrams and transmits them through wires to the connected
EASY control units.
The radio receiver is supplied directly from the EASY signal line
and can be connected anywhere in the EASY signal line.
Construction
The radio receiver is made up of the following components:
• LED (A)
• Connections for EASY signal:
– Modular 4p4c socket (B)
– 4-pin plug-in terminal (C)
• „Connect“ button for training and untraining hand-held trans-
mitters/wall operating units (D)
Untraining the hand-held transmitter/
wall operating unit
Press the „Connect“ button (D) of the radio receiver for 10
seconds.
Activation: The LED (A) of the radio receiver lights up red.