User's Manual

OTC Wireless Document Number: DOC-001-0901
AirEZY2411-RS232 Utility User’s Guide Version 0.2 – Oct 14, 2002
17
i. “Apply”: get the entered data, validate it, and forces the user to re-
entered the invalid data if necessary. If all data is valid, the entered data
will be sent to the unit in the “Set WEP Command”.
ii. “Cancel”: all entered data discard, the “Set WEP Command” is set with
the data set in the Main Window.
4. “Apply” button: when pressed, the program validates any entered data, and forces the
user to re-entered the invalid data if necessary. If all data is valid, the entered data
will be sent to the unit in the “Set WEP Command”.
This area works only if the user has already made a connection (see 3.1).
To retrieve the Unit’s current WEP, the user must click on the “Refresh” button on
the Main Window of the application (at the bottom left of the Main Window), then the
Program sends out a command: “Get WEP Command”. If it succeeds, the Security area will
display the Unit’s current WEP. Due to the security reason, the program only displays the
WEP’s status: it is disable or not. If it is not, display the encryption bits (64 or 128)
To set the Unit’s WEP, the user must click on the “Apply” button on the Security
area (this area), then the Program validates any entered data, and forces the user to re-
entered the invalid data if necessary. If all data is valid, the entered data will be sent to the
unit in the “Set WEP Command”. After sending out the command, the Program waits for a
response from the Unit to verify that the command succeeds. If it is, the Security area will
display the information as in the “Get WEP Command”
3.6 Testing: (Fig 8)
This area intended for Askey Testing purpose only (in-house users). It will be inactivated in
normal user mode.
This area works only if the user has already made a connection (see 3.1).
When in active mode and is pressed, this brings up an “Askey Testing” window as below.