User's Manual

4. Configuring, Monitoring the Base Radio Transceiver (the Server) and the Client

Radio Transceiver (the Client)

Note: The following terms are used interchangeably in this chapter:

2411EZYLINK-E and AirEZY,

Base Radio Transceiver and Server,

Client Radio Transceiver and Client.

Similar to that for modifying the default configuration of the AMU, there are two approaches to configure and

monitor the AirEZY servers and clients. One is to use the web interface, and the other one is to use an

external SNMP manager.

When a browser or an external SNMP manager is used to configure and monitor AirEZY servers and clients,

the device containing the browser or SNMP manager must be connected to the AMU using EthA (marked A

under the RJ-45 connector).

The AirEZY products currently support Telnet utility and Command Interface (CI) utility to configure and

monitor the AirEZY products. However, both Telnet utility and CI utility are described in a different document,

and it is not the scope of this document.

4.1 Using a Browser

When using a browser to configure or monitor AirEZY servers and clients, the following URL should be used.

http://ip_address

Where: ip_addres is the EthA IP address of AMU.

4.1.1 Administrative User Login

The first AMU screen prompts the user to enter the user id and password as well as the configuration option

for AirEZY Control or User Admin. The AirEZY Control option will allow user to configure and monitor AirEZY

configuration and performance. The User Admin option allows system administrator to set up user access to

AMU. The default configuration option is AirEZY Control.