User's Manual

ACR-201-G Technical Manual

If the yellow LED stays on continuously, then the Ethernet connection to the

Ethernet port is not made. Check your UTP cable and make sure that a straight-

through cable is used for connecting it to a host and that a crossover cable is

used for connecting it to a hub or switch. If one cannot communicate, and the

yellow LED is off, you may want to re-position the ACR-201-G to a different

location for better RF reception. You may also want to check if the unit is

configured with the proper RF channel and security settings by using the Web-

based Utility software. Refer to Chapter 3 for instructions on how to change the

RF channel and security settings.

Once the hardware is checked out to work properly with the computer or network

device, the radio can be secured at the top of the laptop LCD display by the

provided radio clip as shown in the following figure.

Stick-on antenna-clip with "corner" shape for edge overhang should prevent user

from mounting it away from the display top corner; such shaped mounting

bracket better than just a flat clip for mounting anywhere.

Typical Installation:

Power drawn from the USB

Ethernet

Connection