User Manual

© SPX Corporation
Operating Instructions for:
014-00071B 61146
014-00072B 61147
016-00029 ADCE-61146
016-00030 D-01001AA
1819 D-01002AA
1820
Form No. 102489
Heavy Duty
Mobile Floor Crane
Max. Capacity 014-00071B 014-00072B
016-00029 016-00030
1819, 61146 1820, 61147
ADCE-61146 D-01002AA
D-01001AA
Boom retracted 2,200 lbs. 4,400 lbs.
Boom extended 1,650 lbs. 3,300 lbs.
Safety Precautions
CAUTION: To help prevent personal injury and/or equipment damage,
•
Read and carefully follow the safety precautions and operating instructions for this floor crane and the pump
and ram used with this floor crane. Most problems with new equipment are caused by incorrect operation or
assembly.
•
Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
•
Do not raise the boom with the legs in the upright position; the legs must be pinned through the cross member.
•
The maximum relief valve pressure setting of any power source used with this floor crane must not exceed
8,800 PSI.
•
Never attempt to lift a load heavier than the rated capacity of the crane boom, because overloaded equipment
can fail.
•
Stay out from underneath a load being lifted or suspended.
•
To prevent tipping: do not lift or move a load that has a center of gravity extending beyond the legs or wheels;
do not move a loaded crane unless the load has been lowered as close to the floor as possible; use extreme
caution when moving a loaded crane on an incline or around a corner, because the load can swing out beyond
the wheels and cause the crane to tip over.
•
Do not modify this floor crane. If a modification is needed, contact OTC Division Technical Services.
•
The owner of the crane is responsible for ensuring that procedures are followed according to federal, state,
and local safety regulations.
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: [phone]
Tech. Serv.: [phone]
Fax: [phone]
Order Entry: [phone]
Fax: [phone]
International Sales: [phone]
Fax: [phone]
Sheet No. 1 of 1
Issue Date: Rev. B, 7-31-02