User Manual

Form No. 528211
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: (507) 455-7000
Tech. Serv.: (800) 533-6127
Fax: (800) 955-8329
Order Entry: (800) 533-6127
Fax: (800) 283-8665
International Sales: (507) 455-7223
Fax: (507) 455-7063
Underhoist Stand
Max. Capacity: 3/4 Ton
The underhoist stand is designed to help support vehicle components during removal or installation.
Safety Precautions
Caution: To prevent equipment failure or damage resulting in personal injury:
Read, understand, and follow these instructions. If the operator cannot read these
instructions, operating instructions and safety precautions must be read and discussed
in the operator's native language.
Wear eye protection that meets the requirements of ANSI Z87.1 and OSHA.
Inspect the condition of the underhoist stand before each use; do not use a stand if it's
damaged, altered, or in poor condition.
Use the stand on a hard, level surface. A stand must have solid contact with the ground.
Test the stability of the load.
Do not attempt to support a vehicle with this stand. It is designed to help support
vehicle components only.
Place the load on the center of the saddle, not on the outer lips.
Do not exceed the rated capacity of the underhoist stand.
Assembly and Operating Instructions
Assembly & Operating Instructions
for: 2015A
1. Attach post support to base.
2. Insert post into post support, aligning holes. Secure with clevis pin,
(2) washers, and cotter pin.
Raise the Load
Turn adjusting handle clockwise until saddle meets load. Continue
turning handle to raise load to required height.
Lower the Load
Turn adjusting handle counterclockwise.
Post
Base
Post
Support
Bearing
(No. 515882)
Sheet No. 1 of 1
Issue Date: Rev. A September 22, 2004
© 2004 SPX Corporation

Summary of content (1 pages)