User Manual

Form No. 539145
Operating Instructions
for: 5192
SPX Corporation
655 Eisenhower Drive
Owatonna, MN 55060-0995 USA
Phone: [phone]
Tech. Serv.: [phone]
Fax: [phone]
Order Entry: [phone]
Fax: [phone]
International Sales: [phone]
Fax: [phone]
© 2006 SPX Corporation
Rev. A, August 22, 2006
Bearing Cup Installer
CAUTION: To prevent personal
injury, wear eye protection that meets
ANSI Z87.1 and OSHA standards.
1. Clean and grease parts to be assembled.
2. Verify needle bearings are in the correct position and are not damaged or missing.
3. Press the bearing cup into the yoke by hand, aligning the holes for the U-joint
cross and the bearing cup bolts.
4. Place the installer onto the bearing cup, threading the bolts into the yoke.
5. Using an impact or hand wrench, turn the forcing screw until the cup is flush to
the yoke.
6. Remove the installer, and assemble the bearing cup bolts.