User's Manual

Performing Advanced Functions

• pmp_low and pmp_high are the programmed values with the PMP

command (irrelevant for the A733GSM)

• type is used to represent the device type; following types are assigned

currently:

0 for A730MD

1 for A720

2 for A730SD

3 for A720B

4 for A733

5 for A723

6 for A440

7 for A733 GSM

8 for A731

9 for A732

• slot and samples are the actual values programmed by means of the

SLOT command

• po is the power output of the device during the last frame sent; this value is

relative (50 mW corresponds to a value of approx. 25 while 500 mW

corresponds to a value of approx. 200) (irrelevant for the A733GSM)

• err_level is the error value; 0 means no error

EMARKS GET only.

REMOTE Yes, GET only. The A733 can issue the command both remotely and locally.

XAMPLE INFO

9193 INFO 255 0 18/4/1999 21:5:11 1.3 0 0 0 91 72 40 1:46 58

65 72 3 900 15 175 0

PORT

AVAILABLE FOR

A731 A733A732 A733GSM

DESCRIPTION A complex command acting upon the I/O ports of a device.

ARAMETERS A control byte specifying the command, the bit of the port the command is acting

on, and two 16-bit parameters, depending on the control byte; for some

commands, one or both of them may be missing. However, if they are needed for a

certain command but not given, null values are implied.

The control byte’s significance is shown in Fig. 17.

Command Code

Port Number

Fig. 17: The Control Byte Layout

• The Port Number selects a the port that will be affected by the command.

For the A733, only 0000 to 0011 are accepted (only four ports are

available).