User's Manual

CHAPTER3
UsingTerminalCommands
23
EXAMPLE # 12800 DATASDI 
12800 DATASDI 
16 5 2003 20 14 49 44 60 255 255 127 87 9 0 9 3 0 0
74.379401 3 0 1 68.117003 3 0 2 58.832397 3 0 3 51.611795 3
0 4 38.346400 3 0 5 19.800799 3 0 6 14.895999 3 0 7 3.553500
3 0 8 0.037200 2953 0

#
FDEV
DESCRIPTION Formats the internal memory (might destroy all the data).
 WARNING The chip configuration setting (first parameter of the command)
depends on the current hardware version and must not be altered.
Please contact our support team for further information.
PARAMETERS If the parameters are missing, the command will show the current
settings. To format the internal memory (all data will be lost) with the
current settings, use 0 as the first parameter. The storage organization
(the index size only), can be optimized for your specific application.
The first parameter for this command is the chip configuration and
second parameter is the index size. The A753 factory setting is:
•1st parameter: 2
• 2nd parameter: 25600
REMARKS GET/SET.
RETURNS Current memory setting.
REMOTE Yes.
EXAMPLE # 42914 FDEV 
42914 FDEV 2 1024+1204 256..32768 25600/0 1888256/0 0 
# 
# 42914 FDEV 2 25600 
42914 FDEV 0 
#
LT
DESCRIPTION This command is used to configure powersave settings for the radio
and GSMmodules. Up to 4 time ranges where the module is on can be
configured (outside these times, the modules are only turned on to
deliver notifications).
PARAMETERS The start time (when to turn on the radio/GSM module) in hh:mm
(00:00 to 24:00), the end time (when to turn off the radio/GSM
module) in hh:mm (00:00 to 24:00) and which entry to modify (0..3,
default is 0).