User's Manual

CHAPTER3
UsingTerminalCommands
24
REMARKS GET/SET.
Time ranges may overlap or wrap around midnight (for example,
23:30 to 00:30). To delete an LT range entry, the from_time and the
to_time must be set to the same value (for example, 00:00 to 00:00).
The following power save modes exist:
• no LT setting: the radio/GSM module is always turned off. This
mode is equivalent to turning on the GSM power saving on an
A733 Series 3.
• the listen times configured for 00:00..24.00: the radio/GSM
module is always turned on. This mode is equivalent to turning off
the GSM power saving on an A733 Series 4.
• the listen times configured for some time ranges. The radio/GSM
module is turned on during that times, and off otherwise.
Note: for outbound connections/commands (getting the initial RTC setting
after powering up, delivering notifications, connecting to the gateway
over GPRS, remote commands to a different device), the radio/GSM
module is turned on independent of the LT settings and stays on until
the time specified by LTNOTIFYTIMEOUT is over!
RETURNS The current settings
REMOTE Yes.
EXAMPLE # lt 15:00 18:00 0
5 lt 0
#
# lt 08:00 10:00 1
5 lt 0
#
# lt
5 lt
15:00 18:00 0
08:00 10:00 1
0
#
LTNOTIFYTMOUT
DESCRIPTION This command is used to configure how long the RTU disables power
saving after a notification is sent.
PARAMETERS The new timeout setting in seconds (0..65535).
REMARKS GET/SET.