User Manual

Otter II Bench Option

Installation and Set-Up Instructions

Installation:

1. Layout all parts.

2. Attach both support bars (Item 3) to the bottom

of the bench (Item 2) with the support brackets

(Item 4). Attach the support brackets using the

#10 x 3/4 bolts (Item 7) into the predrilled holes

in the bench. Ref. Diagram 1.

Parts Identification and Check List:

Sled

(Sold Seperately)

Bench

(Qty 1)

Support Bar

(Qty 2)

Support Bar

Bracket (Qty 2)

Locking Pin

(Qty 2)

Sled Bracket

(Qty 2)

Diagram 1

5/16 Washer

(Qty 4)

5/16 NyLock Nut

(Qty 4)

5/16 x 3/4 Hex

Bolt (Qty 4)

#10 x 3/4

Bolt (Qty 8)

Tools Required:

1/2 Box End Wrench

1/2 Socket and Ratchet

Drill

3/8 Bit

Phillips Screwdriver

PAGE 1
Otter II Bench Option Installation and Set-Up Instructions Parts Identification and Check List: 1 2 Bench (Qty 1) Sled (Sold Seperately) 5 4 3 Support Bar Bracket (Qty 2) Support Bar (Qty 2) 9 5/16 Washer (Qty 4) 10 7 Locking Pin (Qty 2) #10 x 3/4 Bolt (Qty 8) Tools Required: 1/2 Box End Wrench 1/2 Socket and Ratchet Drill 3/8 Bit Phillips Screwdriver 8 5/16 x 3/4 Hex Bolt (Qty 4) 7 3 2 4 Sled Bracket (Qty 2) 5/16 NyLock Nut (Qty 4) Diagram 1 Installation: 1. Layout all parts. 2.
PAGE 2
3. Place the bench seat assembly onto the sled and set to desired position. 4. Slide the sled bracket (Item 6) under the bench seat assembly and on top of the sled (Item 1) lip. Mark the holes to be drilled and drill two 3/8 in. holes. 5. Measure the specified distance (See Note 1) over and attach the second sled bracket (Item 6) by marking the holes to be drilled and drill two 3/8 in. holes. 6.